Auto-Qos Configuration Example - Cisco WS-C2960-24LC-S Software Configuration Manual

Chapter 28 Configuring QoS

Auto-QoS Configuration Example

This section describes how you could implement auto-QoS in a network, as shown in
optimum QoS performance, enable auto-QoS on all the devices in the network.
Figure 28-10
Figure 28-10
enabled on the switches in the wiring closets at the edge of the QoS domain.
OL-8603-04
Auto-QoS Configuration Example Network
End stations
Identify this interface
as connected to a
trusted switch or router
IP
Identify these
interfaces as
connected to
IP
IP phones
Cisco IP phones
shows a network in which the VoIP traffic is prioritized over all other traffic. Auto-QoS is
Cisco router
To Internet
Trunk Trunk
link link
Identify these
interfaces as
connected to
IP phones
Catalyst 2960 Switch Software Configuration Guide
Configuring Auto-QoS
Figure
Video server
172.20.10.16
Identify this interface
as connected to a
trusted switch or router
IP
IP
Cisco IP phones
28-10. For
28-27