I rouuresnuur.ilrg \-f utus
Problem
Cause & Remedy
OThe unit does not work when I press any
I Plug in the AC adaptor then switch the
buttons.
I power on
The unit has been set to the Answer mode. but no
lncoming Messages are recorded.
oThe cassette tape is cut or is nol inserted.
Replace the cassetle with a new one.
aThe OGM is recorded improperly. Record
a new OGM.
OThe recording time mode is set lo
"Announce only".
The unil does not function. However,6 beeps
I aThe cassette tape might be broken
sound and the LCDisplay shows
"Err".
I
Replace it with a new one
.Clean the heads. (See page 73.)
While recording an OGM, 6 beep sounds are
heard, and the LCDisplay shows
"Err".
Re-record your OGM. Speak clearly and
loudly, and do not pause for over 2
seconds while recording.
When the cassette tape is played back, the
I oClean the Heads. (See Maintenance
sound level is low, even if the VOLUME control rs I
instruction on page 73.)
turned up fully
I have played back all the recorded messages
I await for 7 seconds. The unit will be ready
and I want to record the next Dhone call after the I
to record the next ohone call
last previously recorded message.
I a In case of remote operation, just hang up
I press the button of a remote phone, but the unit
d n o c
n ^ i
r o c n h n r i
oMake sure that you are entering your
correct code number.
a R e c o r d t h e O O M i n a q u i e t p l a c e .
Some ICM have not been recorded uo to their
I Set the CPC switch to
"8"
e n d .
| ( S e e p a g e 1 1 . )
Setting the ''Transfer" cannot be done
oTelephone number is not stored into the
transfer memory station
While operating the unit, the AC adaptor may be
warm.
aThrs rs normal condition