Replacing The Retainer Bar - NEC POWERMATE CT User Manual
A powerful, versatile corporate pc
Hide thumbs
Also See for POWERMATE CT:
- Service and reference manual (167 pages) ,
- Configuration manual (1 page) ,
- Release note (8 pages)
Table of Contents
Advertisement
Secure the expansion board in place with the retainer bar (see
7.
"Replacing the Retainer Bar").
Attach any signal cables required by the expansion board.
8.
Replace the cover (see "Replacing the Cover" earlier in this chapter).
9.
Replacing the Retainer Bar
To install the retainer bar, use the following steps.
Hold the retainer bar at an angle and insert the ends into the slots in
1.
the chassis (see the following figure).
Push the bar into the slots and under the edge of the chassis.
2.
Press down on the lock tabs and firmly push the bar in until the tabs
3.
slide into their slots. Be sure that the raised portion on each tab locks
into its slot.
Replace the cover (see "Replacing the Cover" earlier in this chapter).
4.
A – Retainer Bar End
B – Retainer Bar Slot
Replacing the retainer bar
C – Lock Tab
D – Lock Tab Slot
Installing Options 4-15
Advertisement
Table of Contents
