Controlling The Rest Of Your System (In Case Of Sc-27); Operating Multiple Receivers; Setting The Remote To Control Other Components; Selecting Preset Codes Directly - Pioneer Elite SC-25 Operating Instructions Manual

10

Controlling the rest of your system (In case of SC-27)

Chapter 10:
Controlling the rest of your system
(In case of SC-27)
Important
• This section includes explanations for the SC-27's
remote control. For instructions for the SC-25's
remote control, see Controlling the rest of your
system (In case of SC-25) on page 103.

Operating multiple receivers

The remote control included with this receiver can be
used to operate up to three other receivers (of the same
model as this receiver) in addition to this receiver. The
receiver to be operated is switched by inputting the
preset code to set the remote control setting.
• Set the remote modes on the receivers before using
this function (see Remote Control Mode Setup on
page 130).
1 Check that the remote control's MULTI-ZONE
selector switch is set to MAIN and that the operation
selector switch is set to RECEIVER.
2 While pressing MULTI OPERATION, press HOME
MENU.
The remote LCD display shows SETUP.
Use / to select RC MODE, then press ENTER.
3
Use / to select the remote mode.
4
RC MODE 1 to 4 can be selected.
5 Press ENTER to set the remote mode.
The selected mode flashes for 3 seconds.
To operate another receiver, start over from step 1 to
input its preset code.
Setting the remote to control other
components
Most components can be assigned to one of the input
function buttons (such as DVD or CD) using the
component's manufacturer preset code stored in the
remote.
However, there are cases where only certain functions
may be controllable after assigning the proper preset
code, or the codes for the manufacturer in the remote
control will not work for the model that you are using.
Note
1 You can't assign TUNER, HOME MEDIA GALLERY, iPod USB, XM or SIRIUS.
96
en
If you can't find a preset code that matches the
component you want to control, you can still teach the
remote individual commands from another remote
control (see Programming signals from other remote
controls on page 97).
Note
• You can cancel or exit any of the steps by pressing
MULTI OPERATION. To go back a step, press
RETURN.
• After one minute of inactivity, the remote
automatically exits the operation.

Selecting preset codes directly

MAIN MAIN
RECEIVER SOURCE
ZONE2 3
MULTI MULTI
OPERATION OPERATION
DVD DVD BD BD TV TV DVR DVR
HOME MEDIA
TV
VIDEO1 VIDEO1 VIDEO2 VIDEO2 HDMI HDMI GALLERY
USB USB
CH
iPod CD CD CD-R CD-R TUNER
MULTI CH
PHONO PHONO IN XM SIRIUS
INPUT SELECT TV CONTROL
INPUT
AUDIO
1 While pressing MULTI OPERATION, press HOME
MENU.
The remote LCD display shows SETUP.
Use / to select PRESET, then press ENTER.
2
3 Press the input function button for the component
you want to control, then press ENTER.
When assigning preset codes to TV CONTROL, set the
remote control operation selector switch to TV here.
The LCD on the remote displays the component you want
to control (for example DVD or TV).
Use / to select the first letter of the brand name
4
of your component, then press ENTER.
This should be the manufacturer's name (for example, P
for Pioneer).
Use / to select the manufacturer's name from
5
the list, then press ENTER.
TV CONTROL
INPUT MUTE MUTE
AUDIO VIDEO
PARAMETER PARAMETER
TUNE
TOOLS
LIST
TOP MENU T.EDIT
BAND GUIDE
SOURCE
RECEIVER RECEIVER
PRESET ENTER ENTER PRESET
VOL
CATEGORY
VOL RETURN
HOME HOME
MENU MENU
TUNE
iPod CTRL
STATUS PHASE CTRL CH LEVEL
MUTE MUTE
THX MPX PQLS MEMORY
VIDEO
1