Configuring The Procurve Wireless Edge Services Xl Modules; J9003A); Configuring An Ip Address For The Module - HP J4850A Installation And Getting Started Manual

Configuring the ProCurve Wireless Edge
Services xl Modules (J9001A, J9003A)
Before beginning the configuration, backup the current configuration of the
switch. The 5300xl switch software must be updated to version E.10.30 or
later. The ProCurve Wireless Edge Services xl Module (J9001A) and the
ProCurve Redundant Wireless Services xl Module (J9003A) must be running
software version WS.01.03 or later.
N o t e
The term 'module' is used in this section to refer to both the ProCurve Wireless
Edge Services xl Module (J9001A) and the ProCurve Redundant Wireless
Services xl Module (J9003A).
There are four module configuration tasks required:
■
■
■
■

Configuring an IP Address for the Module

By default, the module uses DHCP to get an IP address. The 5300xl switch CLI
has a command context, the wireless services context (accessed from the
CLI's config context), for configuring and managing a module.
N o t e
'ProCurve' is used here as a generic prompt for all 5300xl switches.
To show the module's IP address, first enter the CLI config context on the
5300xl switch, then enter the following command to access the module's
wireless services CLI context for the module:
ProCurve (config)# wireless-services <slot-id>
To display the module's IP address, enter:
ProCurve (wireless-services-id)# show ip interfaces
Configuring the ProCurve Wireless Edge Services xl Modules (J9001A, J9003A)
configuring an IP address for the module
configuring VLANs on the 5300xl switch
determining a module configuration backup process
configuring wireless LAN services
where <slot-id> is the slot in the 5300xl where the module is installed.
Getting Started With Switch Configuration
3-11