5300Xl Switch Configuration - HP J4850A Installation And Getting Started Manual

5300xl Switch Configuration

Configuring the switch consists of assigning switch ports as client downlink
ports and reviewing the uplink VLAN used by the module. The client downlink
ports connect the module to clients, for example, access points. The uplink
VLAN connects the module to the rest of the network and the 740wl/760wl.
By default, it is assigned to the default_VLAN.
To configure client downlink ports, from the CLI command prompt at the
global configuration level
enter access-controller<slot ID> client-ports <port list>
Each client downlink port is assigned to a separate, automatically created
VLAN.
N o t e
If a port is already assigned to an untagged VLAN, it is reassigned as an
untagged member of the new VLAN. If a port is a tagged member of an existing
VLAN, it joins the new VLAN as an untagged member, while retaining its
previous tagged VLAN membership.
If you receive a message 'Command will take effect after saving configuration
and reboot.' use write memory to save the configuration and reload to reboot
the switch. If you have additional client ports to configure do so now, then
save the configuration and reload the switch.
To change the uplink VLAN from the default_VLAN, enter the configuration
context for the new VLAN at the global configuration level
assign the module's uplink to that VLAN as an untagged member
where <slot ID> is the slot where the module is installed. For example, if the
module is in slot 'B' the command to assign the uplink VLAN to VLAN 3 would
be
Configuring the ProCurve Access Controller xl Module (J8162A)
ProCurve Switch 5308xl (config) #
where <slot ID> is the slot letter where the module is installed.
where <port list> is the port(s) to be used as client downlink ports.
ProCurve Switch 5308xl (config) # vlan <vid>
ProCurve Switch 5308xl (config) (vlan <vid>) # untagged <slotID>up
ProCurve Switch 5308xl (vlan 3) # untagged bup
Getting Started With Switch Configuration
3-9