Cisco 2611 - Router - EN User Manual page 77

Figure A-3 Cisco 2611 Rear-Panel LEDs
Link
Link
LED
LED
ACT
LED
SERIA L 1
SERIA L 0
WIC
CONN
2A/S
SEE MANU AL BEFO RE INSTA LLATI
ON
LIN K
ETH ERN ET 0/1
ACT
LIN K
ETH ERN ET 0/0 ACT
Ethernet 0/1
10BaseT
port (RJ-45)
Table A-2 Cisco 2610 and Cisco 2611 Rear-Panel LEDs
LED Description
LINK When on, a link has been established with the hub or switch at
the other end of the cable.
ACT Packets are being transmitted or received on the Ethernet
interface.
Figure A-4 shows the location of the Cisco 2612 rear-panel LEDs and Figure A-5 shows
the location of the Cisco 2613 rear-panel LEDs. Table A-3 describes these LEDs.
ACT
LED
SERIA L 1
SERIA L 0
CONN
CONN
SEE MANU AL BEFO RE INSTA LLATI
ON
CO NSO LE
AUX
Ethernet 0/0
Auxiliary
10BaseT
port (RJ-45)
port (RJ-45)
Console
port (RJ-45)
Reading the LEDs
Cis co 26 11
WIC
2A/S
W0
Troubleshooting the Router A-5