6.10 Inverter board and three-phase asynchronous motor
Remove the worktop.
Remove the right side panel.
Loosen the 2 screws securing the Inverter motor
control board and remove it by raising it slightly
and pulling it outwards.
Loosen the 10 screws that hold the rear air
conduit.
If necessary, use a screwdriver to unhook
the clips that hold it and remove it.
Loosen the bolt that holds the hot air
circulation fan.
Remove it by pulling it outwards.
Technical Support - A.D.L.
38/66
599 74 32-54 Rev.01