Troubleshooting - Husqvarna Z448 Operator's Manual

• Lubricate each set of front wheel mounts (A) and
bearings (B) 3-4 strokes.
A
To lubricate the cutting deck
spindles
1. Set the cutting deck in mow position.
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
Problem
Engine does not start.
The starter motor does not turn the engine
over.
24
2. Lubricate each cutting deck spindle 2-3 strokes.
B
Note:
when you lubricate the cutting deck spindles.

Troubleshooting

Cause
The drive of the blades is engaged. Refer to
Off) button on page 4 .
Steering controls are not locked in the neutral.
The battery is too weak. Refer to
18 .
There is dirt in the carburetor or fuel line.
The shut-off valve of fuel supply is closed or in incorrect posi-
tion.
The fuel filter or fuel line is clogged.
The ignition system is damaged.
The battery is too weak. Refer to
18 .
The connection at the cable connectors on the battery terminals
To clean the battery on page 17 .
is bad. Refer to
A fuse is blown. Refer to
The OPC is damaged. Refer to
Use a grease gun with a rubber hose
PTO (Power Take-
To charge the battery on page
To charge the battery on page
Fuses on page 5 .
Operation conditions on page 9 .
2237 - 001 - 11.08.2023