Troubleshooting - Husqvarna V554X Operator's Manual

Note:
Use a grease gun with a rubber hose
when you lubricate the cutting deck spindles.
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
Problem
Engine does not start.
The starter motor does not turn the engine
over.
The engine does not run smoothly.
2375 - 003 - 13.03.2024

Troubleshooting

Cause
The drive of the blades is engaged. Refer to
Off) button on page 4 .
Steering controls are not locked in the neutral position.
The battery is too weak. Refer to
18 .
There is dirt in the carburetor or the fuel line.
The fuel filter or fuel line is clogged.
The ignition system is damaged.
Incorrect neutral adjustment. Refer to
tion on page 20 .
Incorrect operation conditions. Refer to
page 8 .
A fuse is blown. Refer to
The connection between the cable and the battery is bad. Refer
To remove and install the battery on page 19 .
to
The battery is too weak. Refer to
18 .
Incorrect neutral adjustment. Refer to
tion on page 20 .
The carburetor is incorrectly set.
The fuel filter or fuel jet is clogged.
Incorrect neutral adjustment. Refer to
tion on page 20 .
The choke is engaged and the engine is warm.
The check valve on the fuel tank cap is clogged.
The fuel tank is almost empty.
The spark plug is damaged.
Incorrect fuel mixture or fuel type.
PTO (Power Take-
To charge the battery on page
To adjust the neutral posi-
Operation conditions on
Fuses on page 5 .
To charge the battery on page
To adjust the neutral posi-
To adjust the neutral posi-
27