Troubleshooting - Husqvarna Z572XS Operator's Manual

Always use good quality grease. Always use
recommended oil, refer to
29 .
To lubricate the front wheels
• Remove the dust cap (A). Grease the nipple (B)
with a grease gun until grease comes out from
the top washer.
A
C
• Lubricate the joint bearing of the front wheels (C)
with a grease gun until grease comes out.
Tightening torques
Engine crankshaft bolt
Mandrel pulley nuts
Idler pulley nuts
Idler arm bushing nut
Lug nuts
Blade bolts
Spark plug
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
2320 - 001 - 29.11.2023
Technical data on page
B

Troubleshooting

To lubricate the cutting deck
spindles
1. Remove the footrest plate (A).
2. Lubricate the 3 cutting deck spindles (B) 2-3
strokes.
Note:
Use a grease gun with a rubber hose
when you lubricate the cutting deck spindles.
3. Lubricate the idler arm (C) 2-3 strokes.
50 ft-lb / 68 Nm
17 ft-lb / 23 Nm
30 ft-lb / 40.6 Nm
70 ft-lb / 95 Nm
75 ft-lb / 102 Nm
90 ft-lb / 122 Nm
16.6 ft-lb / 22.5 Nm
A
C
B
25