Lenovo ThinkSystem SD530 V3 User Manual page 95

Procedure
Step 1. Make preparations for this task.
a. Power off the node (see
from the node.
b. Remove the node from the chassis (see
carefully lay the node on a flat, static-protective surface, orienting the node with the front
toward you.
Notes:
• When removing the node, note the node tray number and make sure to install the node in
the same tray from which it was removed. Reinstalling the node into a different tray requires
the node to be reconfigured.
• For safety, make sure to hold the node with both hands when lifting the node.
c. Remove the top cover (see
Step 2. Disconnect all the cables from the drive backplane.
Step 3. Remove the drive cage assembly from the node.
a. Remove the seven screws that secure the cage.
b. Lift the cage out of the node.
Figure 42. Removal of the drive cage assembly
Step 4. Lay the drive cage on a flat, static-protective surface.
After this task is completed
1. Install a replacement unit (see
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
"Power off the node" on page
"Remove a node from the chassis" on page
"Remove the top cover" on page
"Install a drive cage assembly" on page
51); then, disconnect all external cables
168).
88).
.
Chapter 5 Hardware replacement procedures
72); then,
85