Lenovo ThinkSystem SD530 V3 User Manual page 32

Figure 2. Front view of the ThinkSystem SD530 V3 node
Table 9. Components in the front view of the ThinkSystem SD530 V3 node
E3.S drive bay
1
Drive activity LED
2
Drive status LED
3
Pull-out information tab
4
Serial connector
5
1 E3.S drive bays
• Install E3.S drives or drive fillers to these bays (see
• For more information about the drive LEDs, see
2 & 3 Drive activity LED & Drive status LED
For more information about the drive activity and status LEDs, see
4 Pull-out information tab
This tab contains below information:
• Network information such as MAC address and XCC network access label.
• Drive bay numbers.
For more information about this tab, see
page 35.
5 Serial connector
Connect a 9-pin serial device to this connector.
6 External diagnostic handset connector
Connect the external diagnostics handset to this connector.
For more details, see "External Diagnostics Handset" on page
7 Front operator panel buttons and LEDs
For more information about the front operator panel buttons and LEDs, see
page 205.
ThinkSystem SD530 V3 User Guide
22
External diagnostic handset connector
6
Front operator panel buttons and LEDs
7
USB 3.2 Gen 1 (5 Gbps) connector
8
VGA connector
9
"Hot-swap drive replacement" on page
"Drive LEDs" on page
"Identify the system and access the Lenovo XClarity Controller" on
210.
205.
"Drive LEDs" on page 205.
"Front operator panel LEDs" on
94).