Figure 125. Removal of the screws
Step 5.
Remove all the screws from the system board.
Important: When removing the system board from the node, avoid touching the connectors on the
system board. Do not damage any surrounding components inside the node.
Figure 126. Removal of the screws
Step 6.
Remove the system board from the node.
a.
Carefully tilt and hold the rear edge of the system board; then, pivot the system board at an
angle to disengage it.
b.
Gently slide the system board toward the rear of the node; then, carefully lift the system
board out of the node.
.
Chapter 5
Hardware replacement procedures
193