Table of Contents
Advertisement
2. Route the down-firing speaker cables through their routing guides on the palm-rest and keyboard assembly.
3. Connect the touchpad cable to its connector (TP1) on the system board.
NOTE:
The touchpad cable should be folded over the speaker and antenna cables during the connection procedure.
4. Connect the down-firing speaker cables to their connector (SPK1) on the system board.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Follow the procedure in
Display assembly
Removing the display assembly
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information, see step 6 in
computer.
2. Remove the
base
cover.
About this task
The following image(s) indicate the location of the display assembly and provides a visual representation of the removal
procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
Before working inside your
57
Advertisement
Table of Contents
