Installing the heat sink
CAUTION:
The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the heat sink and provides a visual representation of the installation procedure.
Figure 44. Installing the heat sink
Steps
1. Align the screw holes on the heat sink with the screw holes on the system board.
2. Tighten the three captive screws that secure the heat sink to the system board.
Next steps
1. Install the
base
cover.
2. Install the
Nano-SIM card
3. Follow the procedure in
Display assembly
Removing the display assembly
CAUTION:
The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
64
Removing and installing Field Replaceable Units (FRUs)
slot.
after working inside your
before working inside your
computer.
computer.