Panasonic EYADA Series Operating Instructions Manual page 76

HOW TO USE
NOTE
⿟ The lever trigger switch can be
removed as shown in the following
figure.
Lever trigger
switch fixing
screw
Before removing the lever trigger
switch, check that the power switch of
the power adapter is OFF.
Setting Fastening Torque
According to the work, the clutch torque
can be adjusted in 96 steps.
■ Setting Procedure
Remove the clutch cover.
Turn the clutch cover anticlockwise.
Securing ring
18
EN
(cont.)
① To increase the output torque, turn
② To decrease the output torque, turn
Lever trigger
switch
Adjust the torque with the
clutch handle.
①
the clutch handle clockwise.
the clutch handle anticlockwise.
To ensure long and safe use
without causing any failure,
observe the following:
• Set the torque according to the
recommended fastening torque
chart.
P. 19
• Do not use the tool in such a manner
that causes the motor to lock.
Attach the clutch cover.
Turn the clutch cover clockwise.
Securing ring
ATTENTION
⿟ Attach the clutch cover during use
so as to prevent the clutch setting
from being changed unintentionally.
⿟ Fasten the securing ring if it is
loose.
②