Honeywell TR50 User Manual page 58

Follow the below steps to do linkage and monitor sensor failure:
Step 1.
Step 2.
Step 3.
Note: Make sure the sylk device is same in the sensor failure as per the parameter.
When there is a physical failure in the CO
block will report the state in the application.
TR50 - User Guide
From the Palette, Drag and drop the Sensor Failure into the wire sheet.
From the Palette, add a CO
Copy the CO parameter property and paste in the Sylk parameter under
2
sensor failure, click Save.
Parameter and click OK.
2
sensor, this sensor failure functional
2
53