Makita RBC220 Instruction Manual page 10

GB
Assembling of engine and drive shaft
CAUTION:
Before doing any work on the brush cutter or the grass trimmer,
always switch off the motor and pull the spark plug connector of'
the spark plug. Always wear protective gloves!
CAUTION:
Start the brush cutter or the grass trimmer only after having
assembled it completly.
*Insert the nuts M5 (1) into the hex holes in the holder case. Insei
the screws M5 x 30 (2) through the opposite holes and semi-tightei
the screws M5 x 30.
• Insert the nipple (3) of the throttle wire through the square hole,
in the grip until it fits into the square hole in the moving part which
is inside the grip. It should move when the throttle lever is|
squeezed. ; ;
• Insert the shaft into the holder case fully untill the grip end reache
the holder case while passing the throttle wire and the switch cord
(4) through the slot in the holder case.
NOTE:
Match the square drive of the inner shaft to the square hole insid
the holder case by slightly rotating the drive shaft or the suppo
washer on the head case, and you can insert the drive shaft int
the holder case smoothly.
Be cautions not to allow the switch cords to be pinched betwee
the holder case and the grip end.
• Match the hole in the holder case to the hole in the inner sha
and insert the screw M5 x 8 through the holes. Then tighten tit
screw M5 x 8 and the screws M5 x 30 (5).
NOTE:
Squeeze the throttle lever to make sure that the throttle wire mov
smoothly. ^
•Connect the switch cords to the two cords from the engine t!
inserting one into the other. Insert them through the holes in th
cover (6).
10