Quick Memory; Storing Into Quick Memory; Recalling From Quick Memory; Temporary Frequency Changes - Kenwood TS-870S Instruction Manual

9 MEMORY FEATURES
QUICK MEMORY
Quick memory stores a maximum of five frequencies in
a Stack arrangement. As each new frequency is stored,
all previously stored frequencies are bumped to their
next respective Quick memory channel.
When all five channels contain frequencies, storing one
more frequency then bumps all frequencies to the next
channel and the frequency in Quick memory channel 5
is bumped off the stack and erased. Due to the stack
configuration, it is not necessary to specify a memory
channel when you save a frequency to Quick memory.
(24.911) > (14.235 )> (8.111 )> (7.082 )>(3.545 )
Memory 1 Memory2 Memory3 Memoary4 Memory 5
21.200)» (24.91'1)» (14.235 )> (18.111 )»( 7.082 )
Memory 1 Memory2 Memory3 Memory4 Memory 5
2 Turn the M.CH/VFO.CH control to select the Quick
memory channel (1 ~ 5) that you want.
aoc AUTO 354590
3 To exit, press QUICK MEMO [MR].
TEMPORARY FREQUENCY CHANGES
1 Press QUICK MEMO [MR].
\
|
| a= soc aur0
li oe ain
(40.103 )» 21.200)» (24.041) » 14.235 )» (48.111)
Memory 1 Memory2 Memory3 Memory4 Memory 5
Quick memary can only be programmed or accessed if
the VFOs are selected for transmitting and receiving.
That is, Conventional memory channels cannot be used
simultaneously with Quick memory channels.
STORING INTO QUICK MEMORY
Press QUICK MEMO [M.IN] while in VFO made.
+ Each time [M.IN] is pressed, the current VFO data is
written to Quick memory.
* Quick memory channels can store the same types of
data as Conventional memory channels 00 ~ 98.
RECALLING FROM QUICK MEMORY
1 Press QUICK MEMO [MR].
* The current Quick memory channel number
appears.
» If there is no data stored in any Quick memory
channels, then this step will not access Quick
memory.
| See ae |
\
2 Turn the M.CH/VFO.CH contro! to select the Quick
memory channel (1 ~ 5) that you want.
ieee) eae i
fu bu |
wor
ome YL
\
3 Turn the Tuning control to change the frequency.
aac aura
* You can change operating mode by pressing
[LSB8/USB), or [CW/-R], or [FSK/—R], or
[FM/AM].
+ Itis possible to change the frequency tnen press
QUICK MEMO [M.IN] to store the new frequency
in the same Quick memary channel. This action
bumps the old frequency to the next higher Quick
memory channel in the stack, etc., but does not
affect the Quick memory channels that are lower
than the current channel.
4 To exit, press QUICK MEMO [MR].
Note: Quick memory channels can be tuned in this manner while
using the TF-SET function.
QUICK MEMORY = VFO
The current Quick memory channel contents, including
the frequency data plus VFO "A" and/or "B" status, are
transferred to the VFO(s) by this function.
In Quick Memory Recall mode, press [M>VFOQ].
Note: If a Quick memory channel is recalled, then you change the
recalled data, pressing [M»VFO] transfers ine new data to the VFO.
69