Table of Contents
Advertisement
WHEN A LASERVISION DISC IS BEI
G PLAYED
SYMPTOM
CAUSE
5. Disc is rotating but there is no
|e
i
picture
ibe
The TV set is not turned on.
Wrong connections from player to TV.
@
Turn on TY.
®@ Make correct connections
6. Picture
continuously
moves
|@
vertically
The TV vertical hold control is not adjusted properly.
®
Adjust vertical-hold cantroi on TV.
7. Particular disc does not playback
ie
properly. The playback stops in
the middie of the disc program.
The playing surface of the disc is dirty.
The disc is warped.
e
Use a soft cloth and lightly wipe off the
dirt from the surface of the disc. If
necessary, moisten a cloth with diluted
neutral detergent to remove heavy dirt or
fingerprints
®
LD dises only
Put the disc into the protective envelope,
then
place
it on
a flat desk
top
Subsequently,
place a flat board e.g. glass
plate on the disc, and load it with about 4
~ Skgs. lfitis left in this state for one day,
sometimes the warp will be alleviated
Heavy books
about 4 ~ 5 kgs
Glass plate
Protective
Glass plate
envelope
8. Sound is unnatural or distorted. | ¢
CX system is turned ON for disc which has no
mark.
i @
Press D/A/CX to turn CX system OFF.
9. No
sound
output
during | «
playback.
MULTI-SPEED
or STILL/STEP playback is being
performed. Sound is output only during the normal
play mode. The audio signals are not output during
other piayback modes
An analog audio disc with PAL system played.
(No sound is output with analog audio disc with PAL
system.)
@ Press PLAY or PLAY/PAUSE to set the
player to normal play mode.
10. During
STILL playback,
a part
of the screen image shakes.
@
Even if the disc is an active play disc,
there may be some cases in which a fully
still image cannot be obtained, but this
does not mean that the player or the disc
is defective
Ti.CHAPTER
SKIP,
CHAPTER
|e
PROGRAM
PLAY
and
|
CHAPTER
NUMBER
SEARCH
cannot be performed.
Disc in which no chapter numbers are recorded is
loaded
@
Press
DISPLAY
to check
if chapter
number is displayed.
12. Certain discs take too long to |
search or are not searched
it takes time to read the recorded code, depending
on the disc.
e
Press CLEAR and picture will appear.
{At this point, a slightly different scene
from that which has been searched for
may eppear.}
33
<VRB1086>
Advertisement
Table of Contents
