Table of Contents
Advertisement
PREPARATION
To enjoy quality sound thoroughly, place this system in the appropriate positions, and install the components
properly. The following illustrations are the setting images of this system.
Example 1: Placing the speaker beneath your TV
1
1 Subwoofer integrated receiver (SR-300)
Notes
• Do not place this system on/under any other components such as Blu-ray disc player in a pile. The vibration of this system
may cause system failure, etc. in other components.
• Keep enough ventilation space on the front, rear, and bottom side (that attached legs) of this system. Do not place this
system on a thick carpet etc.
• If the picture on your CRT TV screen becomes blurred or distorted, we recommend moving the system away from your TV.
• Low frequency sound produced by the subwoofer integrated receiver may be heard differently depending on the listening
position and subwoofer location. To enjoy desired sounds, try changing the location of the subwoofer integrated receiver.
• Depending on your installation environment, connections to external components can be done before installing this system.
We recommend that you temporarily place and arrange all components in order to decide which procedure is best done first.
Placing the speaker
You can place the speaker on a rack or attach it to a wall. Select an installation method that suits your environment.
■ Placing the speaker beneath/under a TV
y
• If there is any obstacle (TV stand, etc.) under the speaker,
use the supplied stands as shown in Example 1.
• If you are not using the supplied stands as shown in
Example 2, attach the supplied non-skid pads to the
bottom of the speaker.
10
En
Placing
2
Example 1:
With attaching TV
stand
Example 2:
Without attaching
TV stand
Example 2: Mounting the speaker on the wall
2 Speaker (NS-BR300)
Put the speaker on the stands and secure
them with the supplied screws as shown
in the illustration below.
Screw holes
Note
You can adjust the height and width at which to attach
the stands to the speaker horizontally by selecting
screw holes in the back of the speaker.
The above illustration shows attaching the stands
using the lower and inner screw holes.
2
1
Screw holes
Hide quick links:
Advertisement
Table of Contents
