Table of Contents
Advertisement
Figure 19. Installing the base cover
Steps
1. Align the screw holes on the base cover with the screw holes on the palm-rest and keyboard assembly.
2. Snap the base cover into place.
3. Tighten the two captive screws that secure the base cover to the palm-rest and keyboard assembly.
4. Replace the five screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly.
Next steps
1. Follow the procedure in
Memory module
Removing the memory module for computers shipped with a plastic
chassis
Prerequisites
1. Follow the procedure in
NOTE:
Ensure that your computer is in Service Mode. For more information, see step 6 in,
computer.
2. Remove the
base cover for computers shipped with a plastic
About this task
The following image indicates the location of the memory module and provides a visual representation of the removal procedure.
44
Removing and installing Customer Replaceable Units (CRUs)
After working inside your
Before working inside your
computer.
computer.
chassis.
Before working inside your
Advertisement
Table of Contents
