Maintenance - Husqvarna EBE 350S Operator's Manual

9. Make sure that the hotspot is equally applied on the
surface for correct adjustment.
10. Make sure that the impeller (B) and the control cage
(C) are correctly installed in relation to eachother.
C
B
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
2335 - 001 - 14.12.2023
C
B

Maintenance

Before you do
11. Tighten the cage clamps.
12. Use your hands to rotate the impeller and the blast
wheel. Make sure that there are no unusual sounds.
13. Install the hopper. Refer to
hopper on page 22 .
To stop the product
1. Close the valve for the abrasive material. Refer to
operate the valve for the abrasive material on page
12 .
2. Push the stop button for the blast motor (A), the fan
unit (B) and the drive motors (C).
C
3. Turn the ON/OFF switch to the OFF position.
4. Disconnect the power plug from the power supply.
5. Stop the dust collector. Refer to the operator's
manual of the dust collector.
WARNING:
equipment when you do servicing and
maintenance. Refer to
equipment on page 7 .
WARNING:
maintenance, stop the motors and
To remove and install the
A
B
Use personal protective
Personal protective
Before you do the
To
19