Husqvarna DXR 95 Operator's Manual page 130

Problem
The hydraulic oil has
different color.
The remote control
does not start.
The remote control
is on but the control
functions are off.
Some of the control
functions on the re-
mote control are off.
The information cen-
ter display is red.
The arm does not
swing (DXR 95).
130
Cause
If the hydraulic oil is grey, there is water in
the hydraulic system.
If the hydraulic oil is black, there is carbon
formation in the hydraulic system because of
too high operation temperature.
The remote control batteries are not charged. Charge the remote control batteries.
The batteries are in shipping mode. Refer to
Remote control batteries on page 69 .
The radio communication receiver on the
product is off.
No pairing operation between the product
and the remote control is done.
The remote control is not in operation range.
The remote control is too far from the prod-
uct.
There is a fault in a component.
No radio communication between the remote
control and the product because of radio
communication interference.
There is a fault in the antenna for the radio
communication receiver.
The joysticks and the buttons on the joysticks
are not in the neutral position when you start
the remote control.
There is a fault in the joysticks, the knobs
and/or the switches.
The system is off because of safety risks.
There are damaged or loose cables between
the radio communication receiver and the
product.
The system is off because of an error.
The swing lock is engaged.
Solution
Examine where the water enters the hydraul-
ic system. If it is necessary, replace dam-
aged components. Replace the hydraulic oil
and the hydraulic oil filter.
Find the cause for the too hot operation tem-
perature. Replace damaged components if it
is necessary. Replace the hydraulic oil and
the hydraulic oil filter.
Connect the batteries to a charger.
Make sure that the radio communication re-
ceiver on the product is on.
Do a pairing operation between the product
and the remote control.
Make sure that the remote control is in the
operation range.
Connect the remote control and the product
with a CAN bus cable.
Stop all other radio communication equip-
ment that can cause interference.
Make sure that the antenna is correctly in-
stalled. The antenna must align vertically
with the remote control and be in clear view
from the remote control.
Make sure that the joysticks and the buttons
on the joysticks are in the neutral position
when you start the remote control.
In the display, do a check of the "Control
diagnostics". Press the menu button on the
remote control. Select "Control diagnostics"
in the "Controls" menu on the display.
In the display, do a check of the "Control
diagnostics". Press the menu button on the
remote control. Select "Control diagnostics"
in the "Controls" menu on the display.
Connect the cables. Replace the cables if the
cables are damaged.
Do the troubleshooting procedure on error
codes that starts with the numbers "11" or
Fault codes and descriptions
"81". Refer to
on page 131 .
Disengage the swing lock.
1401 - 005 - 11.01.2024