Electrical Safety - Black & Decker BEMW461BH Original Instructions Manual

EnglisH
Keep the cable away from
the cutting blades.
The blades will continue to
rotate after the machine is
switched off.
Directive 2000/14/EC
guaranteed sound power

Electrical safety

Warning! This tool is
double insulated; therefore
no earth wire is required.
Always check that the
power supply corresponds
to the voltage on the rating
plate.
♦ If the supply cord is damaged,
it must be replaced by the
manufacturer or an authorised
BLACK+DECKER Service
Centre in order to avoid
a hazard.
♦ Electric safety can be further
improved by using a high
sensitivity 30 mA Residual
Current Device (RCD).
Features
This appliance includes some or all of the following features.
1. Power button
2. Comfort grip handles
3. On/off switches
4. Upper handle
16
5. Cable management system (BEMW471, BEMW481 GB
units only)
6. Handle knobs
7. Lower handle
8. Grass box handle
9. Rear flap
10. Carrying handles
11. Height adjustment gauge
12. Height adjustment lever
13. Grass box
Assembly
Warning! Before assembly, make sure that the appliance is
switched off and unplugged.
Assembling the grass collection box (fig. A, B, C, D
and E)
♦
The grass box requires assembly before use and comes
in 5 pieces.
♦
Clip the handle (8) into the lid (13a) of the grass box
(fig. B). The handle will only fit one way round.
♦
Clip the 2 sides (13b) and (13c) of the grass collection
box together. Make sure that all clips and guides are
aligned (fig. C).
♦
Align the lid (13a) onto the assembled grass collection
box. Ensure that the 10 guides are aligned (fig. D)
♦
Align the assembled sides onto the bottom (13d) of the
grass collection box. Ensure that the 4 guides are aligned
(fig. E)
♦
Push the 2 parts together. Apply even force around all
edges of the grass collection box securing the clips
into position uniformly. Check that each clip is fastened
together securely.
Fitting the lower handle (fig. F)
♦
Insert the ends of the lower handles (7) into the
corresponding holes in the mower.
♦
Press the handle down as far as it will go.
♦
Secure the handle using the screws.
Assembling the upper handle (fig. g)
♦
Fit the upper handle part to the lower handle using the
handle knobs (6) , washers and screws as shown.
securing the motor cable (fig. H)
♦
The motor cable has to be fixed using the cable restraint.
♦
Snap a restraint clip (14) around the cable and lower
handle about 150mm below the handle knob (6).