ENGLISH (Original instructions) Preparation Intended use Your BLACK+DECKER BEMW461ES, BEMW471ES, While operating the machine always BEMW481ES lawn mowers have been designed for mowing wear substantial footwear and long grass. These appliances are intended for consumer use only. trousers. Safety instructions...
(Original instructions) ENGLISH Prevent body contact with earthed or In that case, do not tilt the appliance more than absolutely necessary and grounded surfaces (e.g. metal railings, lift only the part that is away from the lampposts, etc.). operator. Always ensure that both Operation hands are in the operating position Never operate the appliance with...
ENGLISH (Original instructions) Check for any damage to the Keep all nuts, bolts and screws on appliance, replace or repair any the appliance tight to ensure a safe damaged parts, check for and tighten working condition. any loose parts. Check the grass collector for wear or Take care to keep the mains cable damage and replace it if necessary.
Page 9
(Original instructions) ENGLISH Before use, inspect the extension Use extreme caution when reversing cable for signs of damage, wear and or pulling the lawn mower towards you. ageing. Replace the extension cable Do not put hands or feet near or under if damaged or defective.
Page 10
ENGLISH (Original instructions) Replace a damaged guard or other The use of any accessory or safety device before further use. attachment not recommended for Never leave a running lawn mower use with this lawn mower could be unattended. hazardous. Only use accessories Always release the bail bar to stop the approved by BLACK+DECKER.
(Original instructions) ENGLISH Unless they have been given Vibration supervision or instruction concerning The declared vibration emission values use of the appliance by a person stated in the technical data and the responsible for their safety. declaration of conformity have been Children must be supervised to measured in accordance with a standard ensure that they do not play with the...
4. EasySteer pivot control 5. EasySteer pivot control buttons Beware of sharp blades. 6. Upper handle 7. Handle knobs 8. Cable management system (BEMW471ES, BEMW481ES Beware of flying objects. Keep units only) bystanders away from the 9. Lower handle 10. Back flap cutting area.
Page 13
150mm below the handle knob (7). Ensure that the cable management system Fitting the grass collection box (fig. I) (BEMW471ES, BEMW481ES GB units only) can slide freely from one side to the other. Lift the flap (10) and place the grass collection box (14) Place the bulk of the mains cable on the lawn, close to the ensuring the recesses (14f) fit over the lugs (14g).
Removing Blade (Fig. S, T) tooth file (23) or sharpening stone, maintaining the angle Note: BEMW461ES / BEMW471ES & BEMW481ES all use of the original cutting edge. Check balance of blade. See new winged blades which improves collection vs previous instructions for blade balancing.
Cord or switch Have cord or switch is damaged. replaced at an author- ised BLACK+DECKER BEMW461ES, BEMW471ES, BEMW481ES lawn mower service center. Black & Decker declares that these products described under Grass too long. Increase the height of "technical data" are in compliance with:...
Page 16
Guarantee The undersigned is responsible for compilation of the technical file and makes this declaration on behalf of Black & Decker. Black & Decker is confident of the quality of its products and offers consumers a 24 month guarantee from the date of purchase.