Table of Contents
Advertisement
Icon
Name
Signal Angle
Measured Depth
Tracing Line
Distortion Line
Guidance Arrows
Guidance Line
Cross Hairs
Rotation Arrows
Line Trace Mode Display Elements
Description
Signal Angle appears in place of Current
Measurement (mA) when the detected signal is
at an angle greater than 35°�
Measured Depth shows the approximate
depth of the target line� The depth appears
in either meters (m) or feet (ft)� In addition to
the measured depth reading, Depth Average
displays a Depth Average Report on screen�
Refer to the Depth Average section for more
information.
The orientation and offset of the Tracing Line
indicate the direction of the target line relative
to the position of the receiver� The Tracing Line
appears as a clear, single line when the signal
id undistorted� As the distortion increases, the
Tracing Line appears increasingly fuzzy and the
audio cue increases static noise� The Tracing
Line Distortion Response is enabled by default�
The Distortion Line represents the signal
from the Upper Antenna node� Compare the
Tracing Line and the Distortion Line to estimate
the degree of distortion on the signal� The
Distortion Line is disabled by default and only
appears if the Tracing Line Distortion response
is disabled�
When the Guidance Arrows are touching, they
indicate the point where the strength of the field
is equal on both sides of the receiver�
The Guidance Line shows the alignment of the
Tracing Line and when the orientation of the
SR-24LE is close to the orientation of the utility�
The Cross Hairs are placed at the center of the
Active View Area to represent the receiver's
location�
When the receiver is out of alignment with
the target line, two rotation arrows appear
to indicate the direction you should turn the
receiver to realign with the target line�
SR-24LE/SR-20 – English – 13
Advertisement
Table of Contents
