Agitators - Haier GE PTW600BPR DG Series Technical Service Manual

Agitators

There are two types of agitators for the models
listed in this manual, an impeller and a single
stage agitator. Each works uniquely to give the
desired washability.
Impeller
Agitator
Impeller
Impeller moves cloths in the basket. It takes the
place of a tall agitator. Impellers are designed
to work best with moving material around in the
basket with low water levels.
Impeller Removal
1. Carefully remove the center cap from the
impeller. This can be done with a screw-
driver.
Impeller
Center Cap
– 39 –
2. Remove the hex-head bolt and side the
impeller off the shaft. The spined coupler is
part of the impeller.
Important: The impeller bolt (Part #:
WH02X24374) should be replaced anytime it
is removed for service and torqued to 100-in.
pounds.
Single Action Agitator
The single action agitator moves the clothes back
and forth through the water while gently pulling
clothes from the top of the wash load to the
bottom of the basket. The bottom of the agitator
continues to move clothes back and forth and
circulates them back to the top of the wash load.
Agitator Removal
1. Remove the cap from the top of the agitator.
Agitator
2. Use a long socket extension (approximately
17-inches long) to assist with removing the
hex-head bolt securing the agitator to the
shaft. The splined coupler is part of the
impeller.
Important: The impeller bolt should be replaced
any time it is removed.
Cap