Installed Position - Yamaha YSP-800 Owner's Manual

You can change the beam mode to suit the input source of this unit using the beam mode buttons on the remote control
(STEREO, 3BEAM, 5BEAM, ST+3BEAM or TARGET). Select stereo mode I\)r 2-channel sources, 3 beam mode, 5
beam mode and stereo plus 3 beam mode for 5. l-channel playback.
All the beam modes are available in the t_llowing cases:
• If you selected Parallel to Wall for INSTALLING in AUTO SETUP (see page 30)
• If you selected settings other than CORNER RIGHT or CORNER LEFT for INSTALLED POSITION in BASIC
SETUP (see page 59)
• If you selected FLAT TO WALL for INSTALLED POSITION in MANUAL SETUP (see page 65)
Only stereo, stereo plus 3 beam and target modes are available in the following cases:
• If you selected Angle to Wall or corner for INSTALLING in AUTO SETUP (see page 30)
• If you selected CORNER RIGHT or CORNER LEFT t_r INSTALLED POSITION in BASIC SETUP (see page 59)
• If you selected ANGLE TO WALL OR CORNER for INSTALLED POSITION in MANUAL SETUP (see page 65)
INSTALLED POSITION
i i i LEFT : : :
STEREO Yes Yes Yes Yes Yes Yes
3BEAM Yes No No Yes Yes No
5BEAM Yes No No Yes Yes No
ST+3BEAM
Yes Yes Yes Yes Yes Yes
TARGET
Yes Yes Yes Yes Yes Yes
Yes: the corresporJding beam mode is available.
No: the corresponding beam mode is nol available.
4O