Operating Instructions; Opening The Microreel Case; Inspection Overview - RIDGID SeeSnake microREEL APX Operator's Manual

Operating Instructions

Opening the microREEL Case

WARNING
Make sure the camera is completely in-
side the drum before unlatching and
opening the microREEL APX case. Do
not open the microREEL APX case while
the camera is stored in the camera clip. If
the camera is not in the drum, the push
cable can unwind and cause damage or
serious injury.
Open the microREEL APX case to route the
camera, replace the drum, rewind the push
cable, and to maintain and clean the system.
1. Set the unit on a level surface and lay
it on its back.
2. Unfasten the case latches on either
side of the microREEL APX.
3. Carefully open the front case and lo-
cate the camera head in the push
cable drum.
4. Route the camera head out through
the push cable guide in the front of the
case.
5. Secure the camera head in the clip.
6. Close and relatch the case.
10 – English – microREEL APX / CSx Via
Case Latch

Inspection Overview

To perform a pipe inspection, connect the
CSx Via to the microREEL APX, power on
the system, and connect the CSx Via to HQx
Live or HQ. Push the push cable through the
pipe and observe the display.
Connecting the CSx Via to the microREEL
APX
The CSx Via Wi-Fi inspection device con-
nects to the microREEL APX through the
slip-ring cavity.
1. Remove the shipping cap from the
microREEL APX.
2. Slide the battery into the CSx Via bat-
tery shoe.
3. Remove the shipping cap from the
CSx Via connector.
4. Align the arrow on the connector with
the unlock symbol
insert the CSx Via into the slip-ring
cavity.
5. Turn the CSx Via so that it locks into
place .
When the CSx Via is not
NOTICE
connected
croREEL APX, keep the
shipping cap over the
slip-ring cavity to protect
the electronics inside.
on the frame and
to the mi-