Kenwood TK-230 Service Manual page 19

TK-230/230(SC}
DISASSEMBLY FOR REPAIR
7. Shielding plate removal
1. Remove the 5 screws from the control unit (@).
2. Lift up the shielding plate (@).
8. FPC connector housing removal
1. Release the lock as shown with using a small thin ©
driver (@), then slide the FPC connector housing
(@).
9. Top panel removal
1. Remove the pin plug from the TX-RX unit (@).
2. Resolder the +B wiring from the fuse PCB (@).
3. Remove the RF pin plug from the TX-RX unit with
using a small pench (@).
4. Remove the 2 screws from the frame (@).
5. Then remove the top panel slowly (@).