Wi-Fi - HIKVISION DS-E00HQHI-XB Series User Manual

2. Turn on Enable.
3. Select Mapping Type as Manual or Auto
Auto The port mapping items are read-only, and the external ports are set by the router
automatically. You can click Refresh to get the latest status of the port mapping.
Manual Select an external port type. Click
external port No., or change it according to actual requirements. External Port
indicates the port No. for port mapping in the router.
The value of the RTSP port No. should be 554 or between 1024 and 65535, while
the value of the other ports should be between 1 and 65535 and the value must be
different from each other. If multiple devices are configured for the UPnP™ settings
under the same router, the value of the port No. for each device should be unique.
4. Set the virtual server of your router, including internal source port, external source port, etc. The
virtual server parameters shall be corresponding with your device port.

6.2.5 Wi-Fi

For certain models, after installing a Wi-Fi dongle to your device, the device would be able to
connect to a wireless network, and the channels in your device can be viewed thorough Wi-Fi. For
example, if your device is connected with several network cameras or analog cameras (Wi-Fi
network cameras currently cannot be connected), after the device is connected to a wireless
network, you would be able to access your device and view the connected channels through Wi-Fi.
Before You Start
Prepare a suitable Wi-Fi dongle, and insert it in to the USB interface at the rear panel.
●
Ensure your device support this function.
●
Steps
1. Go to Configuration → Network → General → Wi-Fi .
Digital Video Recorder User Manual
Figure 6-5 NAT
to edit External Port. You can use the default
42