2019/05/15 01:58:50 (GMT+09:00)
2-3. Notes on Replacing the Lens
When replacing the lens, read the QR code of the repair lens.
To read the QR code, start the Adjust manual and press the QR code reader button.
The read data is used in the following processes.
•
Selection of Spacer Plate when mounting the imager board
•
Adjustment after replacing the lens
The QR seal is pasted to the front of the repair lens device and is provided.
Peel off the QR seal, and then paste it on the Heat Conduction Sheet (IM).
Note
Use this QR code, if you cannot extract the data with "Lens data carry" from the SY board.
QR seal
2-3-1. Selection of Spacer Plate when Mounting the Imager Board
1.
Load the Spacer Plate on the QR code reader screen.
2.
The thickness of the Spacer Plate to be loaded is displayed.
3.
Select the Spacer Plate according to the instructions on the screen and mount the imager board.
2-3-2. Adjustment after Replacing the Lens
Perform LOAD from "Lens data carry" on the ADJUST tab in the Adjust manual.
Sheet
QR seal
Heat Conduction Sheet (IM)
Sony CONFIDENTIAL
For Authorized Servicer
11
SYS SET