Gearmotor - Philips Saeco XSmall Service Manual

XSMALL
7.5.

Gearmotor

1
F
D
B
E
A
B
C
2
3
P
H
L
1) Loosen the screws holding the boiler pin in
place, remove it and loosen the other screws
shown
2) The following are located inside the
compartment protected by the casing:
- Brew drive (A) with gears (B) and (C) for
transmission and timing of the dispensing head.
- Grounds drawer present microswitch (D).
- Brewing unit present microswitch (E).
- Microswitch (F) detecting brewing unit home
and work positions.
- Remove the gear (C) that meshes with the
motor transmission shaft
- Remove the large gear (B)
- Remove the motor (A), complete with
transmission shaft
3) Replace the gear (B), making sure that the
imprint of the arrow is aligned with the opening
containing the pin (P)
4) When replacing the motor and the
transmission shaft, make sure the bearings (L)
are in the right position.
Grease the shaft thoroughly and evenly
4
07 DISASSEMBLY
04/08