Table of Contents
Advertisement
8. Attach the control board (E) to the control board
assembly plate. Use the screws, the washers and
the nuts.
E
Introduction
WARNING:
safety chapter before you use the product.
To do before you operate the product
WARNING:
during operation of the product. The shaft
rotates and can cause serious injury.
•
Read the operator's manual carefully and make sure
that you understand the instructions.
•
Read the engine manual that is supplied by the
engine manufacturer.
•
Do the daily maintenance. Refer to
page 21 .
•
Make sure that there are no objects near the product
that can get caught in the shaft during operation.
•
Make sure that the bottom edge of the product
is straight. Adjust with the stretching screws as
necessary and make sure that the locknuts are fully
tightened.
•
Make sure that the direction of rotation of the shaft is
correct for the operation.
992 - 002 - 11.10.2023
Operation
Read and understand the
Do not touch the shaft
Maintenance on
9. Connect according to the description.
F
a) Connect cable socket F to the socket on one end
of cable G.
b) Connect cable socket D to the socket on the
other end of cable G.
c) Connect cable socket C to cable socket E.
d) Connect the cable socket A to the wall socket B.
•
Make sure that the rails are stable. Rails that are not
stable can cause the product to tilt or prevent correct
movement of the product.
•
Make sure that the rails are in line. Rails that are not
in line can make marks on the concrete.
To make the bottom edge of the
product straight
1. When the product is assembled, put the ends on
trestles to free the bottom edge of the product.
2. Attach a string (A) along the bottom edge of the
product.
3. Apply tension to the string to make it straight.
A
B
C
D
E
G
17
Advertisement
Table of Contents
