Operation - Husqvarna LT 8005 Operator's Manual

• Only do the maintenance as given in this operator's
manual. Let an approved service center do all other
servicing.
• Remove all tools from the product before you start
the engine after maintenance. Loose tools or tools
attached to rotating parts can eject and cause injury.
Introduction
WARNING:
safety chapter before you use the product.
To do before you operate the product
• Read the operator's manual carefully and make sure
that you understand the instructions.
• Read the engine manual that is supplied by the
engine manufacturer.
• Do the daily maintenance. Refer to
schedule on page 9 .
To start the product
1. Set the throttle control in the start position.
2. Pull the starter rope handle slowly until you feel
resistance.
3. Release the starter rope handle to let the starter
rope go back to its initial position.
8

Operation

Read and understand the
Maintenance
• After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service center.
• Let an approved service center do servicing on the
product regularly.
4. Push down the decompression lever.
Note:
The decompression lever goes back to its
initial position when the engine starts.
5. Pull the starter rope handle until the engine starts.
Note:
If the engine does not start, do this
procedure again from the start.
6. Let the engine operate at idle speed for 2–3 minutes
before you apply full throttle.
To do if the engine does not start
If the engine does not start and white smoke shows, do
the procedure that follows.
1. Set the throttle control to the stop position.
2. Slowly pull and release the starter rope handle 5
times.
3. Do the start procedure again.
1167 - 004 - 12.09.2023