Pioneer VSX-5700S Operating Instructions Manual page 37

Refer to P.32 for an explanation of i
LOADING BATTERIES
1. Open the battery compartment cover on the rear of the remote
control unit. The cover should open easily if you slide it in the
direction of the arrow while pressing on it with your thumb.
2. Take out the four supplied batteries (LRO3/AM-4}, and insert them
into the battery compartment in accordance with the indications
in the compartment.
3. Close the cover of the battery compartment.
Cover
Reset button
Incorrect use of batteries may lead to leakage or rupture.
Always be sure to follow these guidelines:
A.
Always insert batteries into the battery compartment correctly matching
the positive + and negative — polarities, as indicated inside the
compartment.
B.
Never mix new and used batteries
c.
Batteries of the same size may have different voltages, depending on
their type. Do not mix different type of batteries.
REMOTE CONTROL RANGE
When operating the remote control unit, point the front of the unit at
the front panel of the receiver. The remote control unit may be used
within a range of about 7 meters (23 feet) from the remote sensor,
within angles of up te about 30 degrees.
Performance of the remote control unit is adversely affected in the
presence of strong fluorescent light. Keep such lights away, especially
from the sensor window.
Battery Replacement
When the batteries have run out, the transmit indicator will not ifuminate
even when a key is pressed. Be sure to replace the batteries as soon
as possible. As the programmed functions will be retained in memory
only as long as batteries are inserted, remove the old batteries only if
they can be replaced by new ones immediately.
Also, be sure ta always use the specified batte!
{LRO3/AM-4) alkaline batteries}
NOTE:
When no batteries are inserted, the programmed memory contents will
be erased after 30 to 60 minutes.
. size "AAA"
Select this position for remote control operation of audio equipment such
as a CD player, tape deck, turntable or receiver.
MIDEG:
Select this position for remote contral operation of video equipment such
as a Video disc player {LD player}, VCR or TV.
AUX:
The AUX mode is provided for programming extra commands in case
you have filled up all the keys in the VIDEO and AUDIO modes. if you
da not program any new commands, then only the receiver amplifier
keys will operate in this mode. You may wish to use this mode to assign
extra commands for a second VCR, tape deck etc
* Keys 1 to 12 are used as station keys for TUNER and TV. fin the CD
and VDP modes 1 to 10 are number keys, 11 is the MEMORY, and
42 is the CLEAR key}
* The function keys can be used in all modes
in the AUX mode, only the receiver keys transmit. Use after
programming into memory the commands of your other remote
control unit.
TRANSMIT indicator
This light flashes when remote control signals are being sent.
@ LEARN selector switch
For Pioneer components set this switch to SR RECALL. Set to LEARN
when programming the memory, and set to USE when using the
memory. {more about LEARN switch on page 43.)
(3: LEARN selector
switch selector switch
37
<ARB1250>
<1) TRANSMIT mode