Rear Panel Facilities - Pioneer VSX-5700S Operating Instructions Manual

REAR PANEL FACILITIES
FM/AM ANTENNA terminals
Use these antenna terminals for reception of normal FM and AM
_ broadcasts.
2) GND terminal
Connect the turntable ground fead to this terminal
3 CENTER, REAR PRE AMP OUT and POWER AMP IN
jacks
ICENTER PRE AMP OUT]
When a separate power amplifier is used to drive the center speaker,
connect the power amplifier to this jack
{CENTER POWER AMP IN|
When a separate pre-amplitier is connected and this unit is used as
power amplifier, connect the pre-amplifier to this jack.
{REAR PRE AMP OUT}
When a separate power amplifier is used to drive the rear speakers,
connect the power amplifier to these jacks.
[REAR POWER AMP IN]
When a separate pre-amplifier is connected and this unit is used as
power amplifier, connect the pre-amplifier to these jacks.
() CENTER SPEAKER terminals
Connect the center speaker to these terminals,
NOTE:
Do not allow any of the cord's conductors to protrude from the terminals
or touch any other conductors. Malfunctioning or breakdowns may
occur when conductors come into contact with each other.
Use center speaker of impedance 8Q - 162.
(5) REAR SPEAKERS terminals
Connect the rear speakers to these terminals.
NOTE:
Do not allow ary of the cord's conductors to protrude from the terminals
or touch any other conductors. Malfunctioning or breakdowns may
occur when conductors come into contact with each other.
Use rear speakers of impedance 82 - - 169.
'6 AC OUTLETS
1U.S. and Canadian models}
SWITCHED TOTAL 50 W MAX
Power supplied through these outlets is turned on and off by the
receiver's POWER switch. Total electrical power consumption of
connected equipment should not exceed 50 W.
15
<ARB1250>