In Case Of Difficulty; Specifications - Kenwood KX-W5040 Instruction Manual

In case of difficulty
Fe A
Symptom Cause
Remedy
Noise level is high.
The head is magnetized.
External noise is induced.
The recording level was too low.
A tape recorded with Dolby NR ON is being
played with Dolby NR OFF.
@ Demagnetize the head referring to ''Clean-
ing the head section"'.
@ Install the system apart from other electrical
appliances and TV set.
@ Adjust the recording level referring to ''How
to record''.
Set the DOLBY NR switch to ON. Z
Sound is vibrating. The capstans or pinch rollers are dirty.
Tape is irregularly wound.
Clean the head referring to ''Cleaning the
head section'. P
Wind the tape regularly by fast forwarding,
rewinding or playing it fully from one reel to
another.
Playback or recording starts immediately
when the power is switched ON.
Notes:
The TIMER switch is set to PLAY or REC.
Set the TIMER switch to OFF unless timer
playback or timer recording is required.
1. This unit is microprocessor-controfled, so malfunction may occur due to external noise or interference noise. In such a case, unplug the power
cord, plug it and turn power on again.
2. Do not use contact cleaners because it could cause a maiffunction. Be specially careful against contact cleaners containing oil, for they may
deform the plastic components.
3. With some tapes, a squeaky noise is produced when the tape is stopped automatically. This is due to the tape protection function, and not
a malfunction.
4. Do not use 120-minute tapes, for the tape is too thin and gets easily tangled.
Specifications
Track System..............
Recording System ........
4-track, 2-channel stereo
AC bias (Frequency: 105 kHz)
Harmonic Distortion.....
(at 1 kHz, 3rd H.D. Normal tape)
Less than 0.6%
Heads ...:.............ccee eee A DECK Wow and Flutter.......... 0.08% (W.R.M.S.)
Playback/recording head...... 1 +0.22% (DIN)
Erasing head..............0:0eeeee ] Input sensitivity/Impedance:
B DECK LINE IN ..................... 77.5 mV/50 kQ
Playback/recording head...... 1 Output Level/Impedance:
Erasing head...................0. 1 LINE OUT...........0...... 390 mMV/3.9 kQ
Motors...................005 A DECK eseceSecaeies DC motor x 1
B: DECK wscdeeceezense DC motor x 1 [GENERAL]
17 W
W: 440 mm (17-5/16")
Fast Winding Time .......
Frequency Response:
Power Consumption.....
Dimensions..................
Normal Tape.............. 20 Hz to 15,000 Hz, +3 dB H: 129 mm (5-1/16")
CrOz Tape................. 20 Hz to 16,000 Hz, +3 dB D: 269 mm (10-9/16")
Metal Tape................ 20 Hz to 16,000 Hz, +3 dB Weight (Net)................ 4.5 kg (9.9 Ib)
Signal-to Noise Ratio:
Dolby NR ON............. 65 dB (Metal tape)
Dolby NR OFF............ 57 dB (Metal tape)
Note:
KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
24 kx-ws5040 (En)