U-Line Echelon 2075DWRRSS User Manual page 28

User's Manual
To adjust the temperature set point, touch and hold either the
" " or " " for that drawer for three seconds. When the LED displays
"SP ," lift your finger from the controller and the corresponding LED
will begin to flash the set point. Touch the "
set point displays. Wait 10 seconds for the new set point to be saved.
Wait 24 hours for the temperature to stabilize before checking the actu-
al temperature again. Each wine compartment can be set to 40°F to
60°F.
INTERIOR LIGHTING
The interior lighting can be controlled by the controller. Each time the
light " " symbol is touched, the lighting is scrolled through the following
options:
Touch once – Both compartment lights on.
Touch twice – Top compartment light on, bottom compartment light off.
Touch three times – Bottom compartment light on, top compartment
light off.
Touch four times – Both compartment lights off.
To enter the "black-out mode," touch and hold "
seconds, this will turn off both display temperatures and the cabinet
lights. The unit will continue to maintain the compartment set point tem-
peratures even though they are not displayed. If the light symbol is
touched and held for 10 seconds, the unit will come out of "black-out
mode," the set points will be displayed and the lighting function will be in
one of the four scrolled positions.
When the unit is in "black-out mode," the light will come on
automatically if the drawer is opened. If you do not want the
lights to come on when the drawers are opened, the light
bulbs must be removed. Refer to Light Bulb Replacement.
A flashing indicator light (LED dot) indicates a thermistor
error in that drawer. Call for service.
" or "
NOTE
28
" until the desired
" for approximately 15