Advertisement
ASSEMBLE INSTURSTIONS
Assemble the lid handle (28) and The Handle base (29) using M6x12mm bolts(AA) to the lid.
5
Assemble the Thermometer (27) to the lid. First remove the stronger (no need install back),
Assemble the Lid & body assembly (1) to the cart left &right cart assembly using M6x35 mm
bolts (HH) and M6 nuts (II)
Attention：Stronger is for protection of the part (1) during transportation,no need to install back
after remove.
6
F i r s t As s e m b l e t h e M 6 x 1 2 m m t o th e bo d y , R e s e r v e di s t a n c e o f 5m m , m a t c h s c r e w h o l e s o n
t h e (2) t o (A A ) w h i c h h a v e b e e n i n s t a l l e d t o h a n g (2) o n t h e s c r e w s ,
Then o p e n t h e c o v e r a n d i n s t a l l e d a n o t h e r t w o (A A) i n s i d e o f t h e (1) . A f t e r t h a t , t i g h t e n a l l (A A) .
First Assemble the Bottle opener (7) to the left front panel (3) using M4x10mm bolts(JJ)
7
assemble the M6x12mm to the the left front panel and intstalled one piece of (BB) on the left
of the body. Reserve a distance of 5mm,Then match the screw holes on the
to
(BB)
and
(AA)
don't tignten the screws. Then open the cover and intstalled another one
After that, tighten al screws.
which have been installed.
Hang( 3)
left front panel on the installed screws,
8
don't t i g h t e n t h e s c r e w s .
(3)
left front panel
(BB)
inside of the body.
Advertisement
