Table of Contents
Advertisement
Available languages
Available languages
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Removing or installing mini planer blades
CAUTION:
•
Tighten the blade installation bolts carefully
when attaching the blades to the tool. A loose
installation bolt can be dangerous. Always
check to see they are tightened securely.
•
Handle the blades very carefully. Use gloves
or rags to protect your fingers or hands when
removing or installing the blades.
•
Use only the Makita wrench provided to remove
or install the blades. Failure to do so may result
in overtightening or insufficient tightening of the
installation bolts. This could cause an injury.
► 1. Socket wrench 2. Bolt
1.
Remove the existing blade, if the tool has been in
use, carefully clean the drum surfaces and the drum
cover. To remove the blades on the drum, unscrew
the three installation bolts with the socket wrench.
The drum cover comes off together with the blades.
1
2
3
4
► 1. Pan head screw 2. Adjusting plate 3. Planer
blade locating lugs 4. Gauge plate 5. Heel of adjust-
ing plate 6. Set plate 7. Inside flank of gauge plate
8. Gauge base 9. Back side of gauge base 10. Mini
planer blade
2.
To install the blades, loosely attach the adjusting
plate to the set plate with the pan head screws
and set the mini planer blade on the gauge base
so that the cutting edge of the blade is perfectly
flush with the inside flank of the gauge plate.
3.
Set the adjusting plate/set plate on the gauge
base so that the planer blade locating lugs on the
set plate rest in the mini planer blade groove, then
press in the heel of the adjusting plate flush with
the back side of the gauge base and tighten the
pan head screws.
4.
It is important that the blade sits flush with the
inside flank of the gauge plate, the planer blade
locating lugs sit in the blade groove and the heel
of the adjusting plate is flush with the back side of
the gauge base. Check this alignment carefully to
ensure uniform cutting.
5.
Slip the heel of the adjusting plate into the groove
of the drum.
1
2
► 1. Mini planer blade 2. Groove 3. Set plate
4. Hex. flange head bolts 5. Drum cover 6. Drum
7. Adjusting plate
6.
Set the drum cover over the adjusting plate/set
plate and screw in the three hex flange head bolts
so that a gap exists between the drum and the set
plate to slide the mini planer blade into position.
The blade will be positioned by the planer blade
locating lugs on the set plate.
7.
The blade's lengthwise adjustment will need to be
manually positioned so that the blade ends are
clear and equidistant from the housing on one side
and the metal bracket on the other.
8.
Tighten the three hex flange head bolts (with the
5
socket wrench provided) and hand rotate the drum
to check clearances between the blade ends and
the tool body.
6
9.
Check the three hex flange head bolts for final
tightness.
7
10. Repeat procedures 1 - 9 for other blade.
8
9
10
5 ENGLISH
1
7
3
2
6
5
4
Advertisement
Table of Contents
