Bulk Dump; Eee Reps; Rs485 Network; Rs485 Communication I/O - Yamaha DEQ5E Operation Manual

(3) Bulk dump
The Bulk dump function enables transmission and reception of data between this and another DEQS(E), through
the RS-485 terminal.
Items which can be transmitted or received are as follows.
@ Alfil All the data the DEQSE possesses (Memory contents/System setup, etc.)
e SYSTEM: ina System data such as system setup, etc. of DEQSE.
€ MEMORY............................... One or all of memory Nos. 1 through 40 of the DEQSE (it is possible to
specify a memory No. or "ALL" in the item "NO").
@ ВАМ К. лиз еы нн Опе or all of the menu settings of UTILITY "RS485 PGM CHANGE" of the
DEQSE (It is possible to specify a BANK name or ALL in the item "NO".
«DEQS control display example»
[EN]
El
(4) RS485 network
When using the RS-485 terminal, specify the address of the device to be controlled.
The following items should be set.
Local address and Baud rate settings are displayed simultaneously when controlled by a DEQ5, but cannot be
changed at this point.
(Refer to "Local Address setting" on page 20.)
e GROUP ien Heike * (Broadcast), 1-7
9 DEVICE ..:... esce * (Broadcast), 1-31
w For further information on RS-485 network, please refer to "RS-485" on page 25.
«DEQS control display example?
RSd85 NETWORK
REMIT Wal
A (SES | *
1
(Z) [CEUTSE + 1
ERATE aE
(5) RS485 communication I/O
When parameters are changed, memory is recalled by DEQ5's panel control, or bulk dump is controlled by DEQ5
or a personal computer, and data is transmitted through the RS-485 circuit to a DEQS(E) with identical
communication conditions (the same address).
RS485 communication I/O specifies the transmission contents of the various data, and the reception contents from
other devices.
The contents are as follows.
15