In Case Of Difficulty - Kenwood DP-R4450 Instruction Manual

In case of difficulty
When appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the
table below to see if the problem can be corrected before seeking help from your dealer or service representative.
No power is applied with the POWER
switch ON.
Disc is loaded, player does not play.
Music is interrupted. (Sound is skipped.)
Disc begins to play when power is
switched ON.
Notes:
@ Power plug is loosely connected.
@ With the power plug connected to the
switched AC outlet of an amplifier, the
power of the amplifier is turned off.
@ Disc is loaded upside down.
e@ Disc is loose.
@ Disc is dirty.
@ Disc is cracked.
@ Condensation occured on the optical lens
unit.
@ Disc is not loaded.
e@ Play mode is not entered (The play/pause
indicator Is not lit).
@ Disc is too dirty.
@ Disc is cracked.
@ The connection cords are inserted loosely.
@ Disc is too dirty.
@ Disc is cracked.
@ Oscillation is applied to this unit.
@ The CD player will automatically play when
a disc has been inserted and power is
switched ON.
@ insert the power plug firmly to the AC
outlet.
@ Turn the amoplitier's power ON.
® Load the disce again with its label side up.
@ Insert disc properly.
@ Vipe off the dust on the surface of the disc
referring to "Disc handling precautions".
@ Replace the disc with a new one.
@ Leave the player for about 1 hour so that
the condensation is removed.
@ Loadadisc and press the PLAY/PAUSE key
.
@ Press the PLAY/PAUSE key
@ Wipe off the dust on the disc surface
referring to "Disc handling precautions".
@ Replace the disc with a new one.
@ Connect all connection cords firmly.
@ Wipe off the dust on the disc surface
referring to "Disc handling precautions".
@ Replace the disc with a new one.
e Try selecting a place where no strong vi-
brations occur by changing the installation
place, etc.
@ Toavoid disc playing automatically, remove
disc before switching off power.
1. This system is microprocessor-controlled, so malfunction may occur due to external noise or interference noise. In such a case, unplug the power
cord, plug it and turn power on again.
2, Donotuse contact cleaners because it could cause a malfunction. Be specially careful against contact cleaners containing oil, for they may deform
the plastic components.
DP-R4450 (En) 19