In Case Of Difficulty - Kenwood D-S300 Instruction Manual

In case of difficulty

What appears to be a malfunction may not alw ays be serious. If your unit should not perform as expected, consult the
table below to see if the problem can be corrected before seeking help from your dealer or service representative.
Operation to reset
The microcomputer may fall into malfunction (impossibil-
ity to operate, erroneous display, etc.) w hen the connec-
tion cords are unplugged w hile unit is ON or due to an
external factor. In this case, execute the follow ing method
to reset the microcomputer and return it to normal condi-
tion.
CD player unit
Symptom
The unit is not turned ON w ith the ON/
STANDBY( ) key ON.
Disc is loaded, player does not play.
No sound.
Music is interrupted. (Sound is skipped.)
Downloaded from: http://www.usersmanualguide.com/
Unplug the pow er cord from the pow er socket and plug
the pow er cord into the socket again.
÷ Please be aw are that resetting the CD player w ill erase all stored
information and return it to the factory settings.
Cause
÷ Pow er plug is loosely connected.
÷ With the pow er plug connected to the sw itched
AC outlet of an amplifier, the pow er of the
amplifier is turned off.
÷ Disc is loaded upside dow n.
÷ Disc is loose.
÷ Disc is dirty.
÷ Disc is cracked.
÷ Condensation has occurred on the optical lens
unit.
÷ Play mode is not entered.
÷ Disc is too dirty.
÷ Disc is cracked.
÷ The connection cords are inserted loosely.
÷ Disc is too dirty.
÷ Disc is cracked.
÷ Oscillation is applied to this unit.
Remedy
÷ Insert the pow er plug firmly to the AC outlet.
÷ Turn the amplifier's pow er ON.
÷ Load the disc again w ith its label side up.
÷ Insert the disc properly.
÷ Wipe off the dust on the surface of the disc
referring to " Disc handling precautions" .
÷ Replace the disc w ith a new one.
÷ Leave the player for about 1 hour so that the
condensation is removed.
÷ Press the 6 key.
÷ Wipe off the dust on the disc surface referring
to " Disc handling precautions" .
÷ Replace the disc w ith a new one.
÷ Connect all connection cords firmly.
÷ Wipe off the dust on the disc surface referring
to " Disc handling precautions" .
÷ Replace the disc w ith a new one.
÷ Try selecting a place w here no strong vibra-
tions occur by changing the installation place,
etc.
D-S3 0 0 (En)
2 5
¢
¢
¢
¢