Table of Contents
Advertisement
4 SERVICE MODE
4.1 Service Mode Activation
The activation of the Service Mode is depends on the Software, which is loads on the electronic. There are
two variants of activation in the Service Mode.
Variant 1:
•
Switch on the appliance
•
Open the door
•
Unplug the appliance
•
Plug in the appliance
Variant 2:
•
Switch on the appliance
Then valid for both:
•
After 6 sec. pressing any push button („action"-key) except the On/Off-button for 5 sec.
The push button must be pressed in the timeframe from 6 to 16 sec, otherwise the Service Mode
o
is not activated.
The Service Mode activation is confirmed by a short beep from the buzzer device.
•
Define the „action"-key choosing any push button except the On/Off-button. With the „action"-key, you
can activate the Service Mode and switch on and off the components.
•
Define the „next"-key choosing any push button except the „action"-key. With the „next"-key, you can
change in a new test-phase.
4.2 Component test
The component tests are different notified in the several phases on the user interface.
All LEDs on or off
„SUPER FREEZING"-sign on or off
„FROSTMATIC" word on or off
On LCD on or off
On LCD on or off
4.3 User Interface visual test
Depending on the version of the appliance, all notification on the display and LEDs are switched on.
Pressing the push button „next".
All notifications on the display and LEDs are switched off. The push button „action" is not used in these
phase.
Pressing the push button „next" again to goes in the next phase.
SOE/TD - PR
ERF803
ERF805
ERF809
ERF810
ERF906
5/8
LED + digits
LCD on door
LCD AEG
LCD on door with New Glass
AUS LCD for Electrolux Kelvinator
599 73 16-18
Advertisement
Table of Contents
