Mounting And Grounding; Connectivity - AEG ARE i2.0x LF Manual

Manual ARE i2.0x LF release V2

2.1.4 Mounting and grounding

Mounting is recommended via the top hat rail connector on the back of the unit.
Note: Grounding of the unit can be achieved by grounding the top hat rail. The top hat rail connector is hooked up to
internal system ground. Alternatively mounting straps are optionally available.

2.1.5 Connectivity:

ARE i2.0x LF is connected via its M12, 5-Pin male A-coded plug. Power supply as well as communication is provided by user.
Do only use specified cables. ARE i2.0x LF uses a LED lit RFID symbol on its front side to visually communicate its various
states (standby, reading, successful read, no read, error, and so on...). When ARE i2.0x LF is hooked up to power, the internal
LED is switched to standby color. LED colors can be set by the user.
Manual ARE i2.0x LF release V2.docx
Top hat rail
connector
Connected to
internal ground
Grounding pin can be
used alternatively to
ground ARE i2.0x
PIN 1 – +7V...24V DC
PIN 2 – GND
PIN 3 – RX
PIN 4 – TX
PIN 5 – CGND
LED: Status indication
cable: M12, 5-Pin A-coded, socket to power 2 cables)
and serial interface 3 cables)
Version: 13
Page: 6 / 34