Hardware Installation; Network Connection - Draytek Vigor 2927 Series Quick Start Manual

3. Hardware installation

This section will guide you to install the router through the hardware connection and configure the settings of
the router through the web browser.
Before you start configuring the router, you need to connect your devices correctly. (For
hardware connection, we take

3.1 Network connection

1. Connect the Cable Modem / DSL Modem / Media Converter to any WAN port of the router with
Ethernet cable (RJ-45).
2. Plug one end of an Ethernet cable (RJ-45) into one of the LAN ports on the router and the other
end of the cable (RJ-45) into the Ethernet port on your computer.
3. Connect one end of the power adapter to the router's power port on the rear panel and the
other end to a wall outlet.
4. Turn on the device by pressing the power switch on the rear panel.
5. The system begins to boot. After completing the system test, the ACT LED will turn on.
will light up and start blinking. (For detailed information on the status of the LEDs, see section 3.
Explanation of the panel)
el "ac" model as an example.)