Table of Contents
Advertisement
MAKING A SAMPLE CAMERA RECORDING
1. Connect the POWER SOURCE.
(See pages 9 and
10.)
2. Press "EJECT" button and insert the cassette so
the transparent window
is toward
you and the
arrow
toward
the
cassette
holder.
Slide
the
cassette into cassette holder as far as it will go.
NOTE:
If the power source is not connected to
camera/recorder, the cassette holder will not open.
. Press the cassette holder.
the operating position.
The holder will latch in
"EJECT" Button
Cassette
Holder
. Slide "VCR/CAM"" select switch to "CAM".
. Slide "POWER"
ON/OFF
switch to on.
The
camera/recorder
will enter
record/pause
mode
automatically.
;
"POWER" ON/OFF Switch
"VCR/CAM" Select Switch
E12
6.
7.
8.
Set "IRIS" contro! to AUTO (center).
Set "FOCUS AUTO/MAN"" switch to "AUTO".
Set "NEGA/POSI" switch to "POSI".
NOTE:
See page 30 for "EYEPIECE
ADJUST-
MENT".
"NEGA/POSI"
"FOCUS AUTO/MAN" Switch
. Now, press record start/stop button to start shoot-
ing the picture.
""REC" indication appears in the
viewfinder and you are now recording the picture
you see through the viewfinder.
. Press record start/stop button to stop recording.
Press the button again to resume recording.
The
"PAUSE?" indication in the viewfinder appears in-
stead of "REC"
in the record/pause
(stand-by)
mode.
NOTE: The "TAPE END" indication in the view-
finder starts flashing when there is less than three
minutes recording time left on the cassette.
Record Start/Stop Button
Advertisement
Table of Contents
